Want To Paint a Room? Read This Before For Basic Painting

A quality paint job is one of the least expensive ways to transform your home and make any room look good. This is basic painting tips for paint a room.

Make Preparations

The first step and the key step is preparations. First, carefully inspect walls for cracks, holes, dents, or other surface imperfections before priming or painting. Use a lightweight spackling compound and putty knife to fill and repair any holes or imperfections.

Then remove any excess spackling with the putty knife and allow the area to dry completely. Once dry, use a small piece of very fine, 220 grit sandpaper or a sanding sponge to smooth the repaired areas flush with the surface.

Wipe the walls clean with a damp towel or sponge. And allow them to dry before priming or painting.

Estimate Paint You’ll Need

The general rule when buying paint is one gallon will cover about 400 square feet. Use the old length times height equation to get the square footage of each wall. For the trim, use length in feet and 0.5 for the width.

Paint Tips: Top to Bottom

So here’s the general plan: work from the top down. Do the ceiling then the walls and finish with the trim. If you’re using more than one gallon, mix them in a 5 gallon bucket to ensure color consistency. This is called boxing. A smaller cut bucket works great for the edges.

For paint a room, Painting the ceiling is a similar process to how you’ll paint the walls brush the edges then use a roller. Remember to avoid spatter don’t roll too fast. Once it’s dry you can mask off the edges with painter’s tape and start on the walls.

To paint the edges, or cutting in, dip the brush about a third of the way into the paint and tap it against the sides no scraping. Holding the brush like a pencil, paint with smooth strokes, feathering out the edges to prevent runs.

Getting a little bit on the trim won’t matter since you’re painting that later, but try not to be super messy. Now for the roller, If you’re using a bucket, you’ll need a roller grid.

Using Pans for Easy Cleanup

For pans, use a liner for easy cleanup. To help the paint load, first dampen the roller cover with a wet rag. Dip just a little ways into the paint and roll a few times to even it out.  Resist the urge to submerge the roller. It’ll make a mess.

Paint a RoomStarting near the edge, roll the paint on in a zig-zag pattern. It helps to roll in several directions to get good coverage, especially on textured walls.

Go slow to avoid paint splatter and don’t press and squeeze the roller to get more paint out of it just reload. Work in 4 foot sections, top then bottom when you paint a room. Once you get going you can go back along the edges.

A few tips: turn the roller sideways to get really close to the ceiling and baseboards. And to remove buildup and runs, lightly roll down over the painted areas. This is called laying off. Paint one wall at a time for each coat, two coats for the room. If you need to take a break, cover your bucket, and wrap up your brush and roller.

Put them in the fridge if you’ll use them the next day. After the walls are completely dry, grab some painter’s tape for the trimwork. Run it against the wall trim edge and press it down with a plastic putty knife. Now you’ll have straight lines on your trim. Once you’ve painted the trim, you’ll want to remove the tape. A knife can help cut along spots where it’s stuck.

Remove it shortly after it’s dry. This will prevent peeling. Some tapes have specific removal time recommendations, so make sure you check before you pull it. off.

Clean the Brush

Finally, cleanup. For latex paints, run the brush under water and use a cleaning brush to clean the paint from the bristles. Work some hand cleaner into it, rinse again and reshape the brush. Use a 5 in 1 tool for roller covers and store upright.

Leave A Reply

Your email address will not be published.